Gas to Induction Cooktop Install - Stanmore

We installed a new induction cooktop for Tim in Stanmore, and it's one we were glad to get.

Tim's a return client. We were out at his place a few years back doing ceiling fans and lighting. Since then he's had solar and a battery put in, so when he asked about swapping gas for induction it was a bit of a no brainer. A house running on its own solar and battery is exactly the house an induction cooktop belongs in. Dinner cooked off the sun.

The kitchen was already finished, and Tim had bought his induction cooktop to replace the gas one sitting in the bench.

Induction isn't a straight swap for gas. It draws a lot more power, so it needs its own dedicated circuit back to the switchboard. That was the real job.

The gas had already been disconnected and Tim had taken the old cooktop away, so we walked into a clean space. New 6mm cable from the switchboard, up through the roof space and down into the kitchen on its own 32 amp circuit. A new safety switch in the meter box, and a STOVE isolator beside the cooktop so the power can be cut without hunting for the switchboard.

While we were there, Tim asked us to fit an outside light over the house number to add a bit of character to the front. We threaded the cable up the cavity so the only thing you see is the light, and not conduit running down the wall.

The fit was the thing to watch. The new cooktop had to drop into the existing stone cut-out, and it did, which saved Tim a stonemason.

Tested it all and Tim's cooking on induction.

If you're thinking about going from gas to induction, that's a job we do every week across the Inner West.

No items found.

Contact Westcork Electrical

Do you need expert electricians in your home today?
Contact us today for a free quote.

Location
Strathfield, 2135